Dyson DC 35 Vacuum Cleaner Manual

The Dyson DC 35 is a cordless vacuum cleaner designed for versatile cleaning. It features a lightweight design, powerful suction, and a detachable long-reach wand for cleaning high and hard-to-reach areas. The vacuum is equipped with a motorized brush bar for deep cleaning carpets and a combination tool for various surfaces. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Accessories 7. Using the Vacuum 8. Maintenance and Care 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Cordless design, motorized brush bar, detachable wand, combination tool, and crevice tool.

Feature	Description
Cordless Design	Allows for easy maneuverability without the hassle of cords.
Motorized Brush Bar	Deep cleans carpets and removes dirt from various surfaces.
Detachable Wand	Extends reach for cleaning high areas and tight spaces.
Combination Tool	For versatile cleaning on different surfaces.
Crevice Tool	For cleaning narrow gaps and corners.
Charging Dock	Convenient storage and charging solution.
HEPA Filter	Captures allergens and expels cleaner air.

Installation

Unpack the vacuum and inspect contents. Place the charging dock in a convenient location.

Attach the wand to the main body of the vacuum.
Connect the desired cleaning tool to the wand.
Plug in the charging dock and place the vacuum on it to charge.

WARNING! Ensure the vacuum is charged before first use.

First-Time Setup

Power on the vacuum; ensure it is fully charged before use.

Press the power button to turn on the vacuum.
Select the desired cleaning mode using the mode switch.
Begin cleaning by using the appropriate tool for the surface.

CAUTION! Avoid using the vacuum on wet surfaces.

Specifications

Model: Dyson DC 35.
Power: 28V lithium-ion battery.
Run Time: Up to 20 minutes on standard mode.
Weight: 5.5 lbs (2.5 kg).
Filtration: HEPA filtration system.
Charging Time: Approximately 3.5 hours.
Dust Capacity: 0.09 gallons (0.34 liters).

Controls and Settings

Power button located on the handle. Mode switch for selecting between standard and max power modes.

Maintenance: Regularly check and clean the filter; empty the dust bin after each use.

Connecting Accessories

Attach accessories by aligning and pushing them onto the wand until they click into place.

Ensure the vacuum is powered off before changing accessories.
Match the accessory to the wand or main body.

Tip: Use the combination tool for versatile cleaning on different surfaces.

Using the Vacuum

For optimal performance, use the vacuum on carpets and hard floors.

Power on the vacuum and select the desired mode.
Move the vacuum back and forth to clean the surface.
Use the wand for high or hard-to-reach areas.

WARNING! Do not block the suction inlet while in use.

Maintenance and Care

Regularly clean the filter and empty the dust bin to maintain performance.

CAUTION! Do not wash the vacuum body; only clean the filter and accessories.

Regulatory Information

This vacuum complies with all applicable safety standards and regulations. For support, visit www.dyson.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Vacuum won't turn on	Battery not charged	Charge the vacuum for at least 3.5 hours.
No suction	Clogged filter/dust bin	Empty dust bin and clean the filter.
Brush bar not spinning	Blocked brush bar	Remove blockage and clean the brush bar.
Battery drains quickly	Old battery	Replace with a new battery.

Reset: If issues persist, contact customer support.

Service: Visit www.dyson.com for assistance.